catholicgugl.blogg.se - Jump starter with air compressor

Jump starter with air compressor how to#
Jump starter with air compressor full#
Jump starter with air compressor professional#

NOTE: Completely disconnect the charger cable when the engine is not running. When the battery is fully charged, disconnect the accessory cable from the unit, and then from the lighter socket of the vehicle.

Monitor the progress of the charge by pressing the Battery Status button on the front of the unit.

Using this method to charge the battery overrides the maintain mode and the battery can be overcharged. NOTE: The RED LED does not operate during this method of charging.

Insert the other end of the accessory cable into the vehicle’s accessory outlet (lighter socket).

Insert one end of the accessory cable into the 12V DC power outlet.

IT COULD EXPLODE, CAUSING PROPERTY DAMAGE OR PERSONAL INJURY. IMPORTANT: DO NOT CHARGE INTERNAL BATTERY FOR MORE THAN 30 MINUTES OR LEAVE THE BATTERY UNATTENDED. You may also charge the internal battery while driving, using a male-to-male charger cable (part number 94500109 – not included). CHARGING THE INTERNAL BATTERY WHILE DRIVING

Charge the jump starter as soon as possible after use.

When in maintain mode, the GREEN LED will light, as long as there is an AC cord connected to the charging port.

Jump starter with air compressor full#

When the internal battery is fully charged, the charger will automatically go into maintain mode and maintain the battery at full charge without damaging it.When the RED LED turns off, the jump starter is ready to use. Complete charging may take up to 72 hours. While the jump starter is charging, the RED LED will be on.Plug the extension cord into a 120VAC electrical wall outlet.To charge, flip the AC connector on the back of the unit DOWN and plug in an 18 AWG or larger extension cord.NOTE: Use of an improper extension cord could result in a risk of fire and electric shock. CHARGING THE INTERNAL BATTERYĬharge the unit’s internal battery using an extension cord (not included). RED – less than 20% of full charge immediately charge the unit.The LED lights will indicate the current charge level as follows: Press the Battery Status button on the front of the unit. IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH USE AND EVERY 30 DAYS, TO KEEP THE UNIT’S INTERNAL BATTERY FULLY CHARGED AND PROLONG BATTERY LIFE.ĬHECKING THE LEVEL OF THE INTERNAL BATTERY Air compressor adapters and storage bag CHARGING THE INTERNAL BATTERY OF THE JUMP STARTER.Never smoke or allow a spark or flame in the vicinity of the battery or engine.A battery can produce a short circuit current high enough to weld a ring to metal, causing a severe burn. Remove all personal metal items from your body, such as rings, bracelets, necklaces and watches.Neutralize any acid spills thoroughly with baking soda before attempting to clean up.If battery acid comes in contact with eyes, flush eyes immediately for a minimum 10 minutes and get medical attention.Wash immediately with soap and water and seek medical attention. Have plenty of fresh water, soap and baking soda nearby for use, in case battery acid contacts your eyes, skin, or clothing.Wear complete eye protection and protective clothing when working near lead-acid batteries.Do not use for dry cell batteries that are commonly used with home appliances.

Use the jump starter for jump starting lead-acid batteries only.If the engine fails to start after the recommended number of attempts, disconnect the unit and look for other problems that may need to be corrected.Use ONLY on vehicles, boats and garden tractors powered with a 12V DC battery system.The jump starter is NOT designed to be installed as a replacement for a vehicle battery.

Jump starter with air compressor how to#

If someone else uses the jump starter, ensure they are well informed on how to use it safely, and have read and understood the operating instructions.

Never operate the jump starter if it is damaged.

Use of an attachment not recommended or sold by the jump starter manufacturer may result in damage to the unit or personal injury.

To prevent arcing, never allow the clamps to touch together or to contact the same piece of metal.

Never place the jump starter directly above battery being jumped.

Never attempt to jump start a frozen battery.

Do not expose the jump starter to rain or snow.

Place the jump starter as far away from the battery being jumped as the cables will permit.

Do not set the jump starter on flammable materials, such as carpeting, upholstery, paper, cardboard, etc.

The jump starter gets hot during charging and must have proper ventilation.

Do not recharge the jump starter with a damaged extension cord.

Do not use the jump starter to jump a vehicle while charging the internal battery.

Incorrect assembly may result in fire or electrical shock.

Jump starter with air compressor professional#

Take it to a qualified service professional if service or repair is required.